Ellipse Dining Table

Solid European white oak, hand-finished in Vilnius. The Ellipse pairs an oval top with a sculptural, interlocking arched base — inspired by Gothic and Roman arches, reworked into something lighter and more modern.

Available in whitewash oil or teak stain. Choose your size below, or get in touch for a fully custom size, wood, or finish.

Made to order — most sizes ship in 4–8 weeks. We ship worldwide. Delivery is quoted separately once we know where the piece is going — within the EU it is typically €100–250 depending on the location.

The base came before the top. It began as a drawing of an arch — the kind you find in a Gothic doorway or a Roman aqueduct, where the curve carries the load rather than decorating it.

Translated into oak, that arch becomes two interlocking pieces that brace one another. They sit inboard from the ends, which leaves the corners of the table clear — nobody ends up sitting around a leg.

The oval top follows from the base. A rectangle would have fought the curve; an ellipse continues it. It also changes how people sit, because an oval has no head of the table.

Solid oak is a living material. It takes up and gives off moisture with the seasons and moves slightly as it does — the construction allows for that. A few habits are what keep a piece looking right for decades.

Everyday cleaning. A soft cloth, damp with water, is all it needs. Wipe spills as they happen: oak is porous and standing water will leave a mark. No solvents, no ammonia-based cleaners, no silicone polish — they degrade an oiled finish.

Heat and humidity. Use mats under hot dishes. Aim to keep the room between 40% and 60% relative humidity and avoid rapid swings. A table pushed against a radiator, or standing in a newly built room that is still drying out, will move more than one in a settled space. Underfloor heating is fine; a heat source concentrated on one side is not.

Light. Oak changes colour as it ages. Raw and lightly stained oak ambers over the first year, then settles. Avoid leaving objects in the same spot for months, or you will find a pale rectangle underneath when you move them. Prolonged direct sunlight accelerates all of this.

Re-oiling. Once a year, or whenever the surface starts to look dry or feels rough under the hand. Clean it, let it dry, apply a thin coat of hardwax oil with a lint-free cloth, and wipe off the excess after twenty minutes. No sanding needed.

Marks and dents. This is the advantage of solid timber over veneer: it can be repaired. Light marks come out with fine abrasive paper — 240 grit or finer, worked along the grain — followed by re-oiling, and the repair disappears. For anything deeper, write to us before you start.

Moving it. Lift, do not drag. Carrying a dining table by its top puts the whole load through the joints.